Home > Maximum Motorsports > K Members >

  Maximum Motorsports Front K-Member - For 79-95 Mustangs w/ 5.0L Engine
Front K-Member - For 79-95 Mustangs w/ 5.0L


 
Market Price $729.95
Sale Price $649.95


Availability: Usually Ships in 24-48 Hours
Product Code: 1503
Qty:

Product Details
 
Product Details
  • Maximum Motorsports spent over two years optimizing our K-Member, both on the track and on the computer. The result is that the front of your car will corner like nothing else you've experienced. Unlike other K-Members on the market, strength, stiffness, and durability are given a higher priority than ultra-low weight so that your investment will last the life of your vehicle.

    What makes the Maximum Motorsports K-Member Different:
  • MM's K-Member lengthens the wheelbase 3/4", which improves the front/rear weight distribution and increases caster.
  • MM optimized the vertical location of the control arm pivots. This improves the camber curve on lowered vehicles and improves the roll center height.
  • MM's K-Member offers two different vertical locations for the control arm pivots, allowing you to choose the one that's best for your car's ride height.
  • MM optimized the location of the steering rack for the greatest improvement in Ackerman steering geometry, which helps reduce understeer and tire wear.
  • After extensive testing of anti-dive, MM determined that Ford got it right! The stock amount of anti-dive is best, and that is what we built into our K-member.
  • MM's K-Member allows 5.0 engines to be set back one inch.
  • The MM K-Members are modular, allowing 5.0 engines to be installed in 96+ cars, or modular engines to be installed in pre-96 cars.
  • Increased oil-pan clearance for all aftermarket oil-pans means oil-pan service is easier.
    Header clearance is increased by over 1" in critical areas.
  • Easier access to the starter motor.
  • Pre drilled plumb bob holes for easy and accurate squaring of the K-member to the car.
  • The factory Ford K-Members weigh on average 50lb. The MM K-Member weighs 36lb.

    In addition to the K-Member, you will also need the following:
  • Tubular front control arms (stock control arms are not compatible because of the large outside diameter of the pivot bushings)
  • Caster/Camber plates
  • Front Coil-Over conversion kit
  • Aluminum steering rack bushings
  • Adjustable Tie-Rod Ends (bumpsteer kit)

    Fits 1979-1995 Mustangs with 5.0L short block engine

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Maximum Motorsports > K Members
K-Members